Airtac VMP1/VMP2 Shotgun Shell HPA Adapter - PLUG AND PLAY

Airtac VMP1/VMP2 Shotgun Shell HPA Adapter - PLUG & PLAY

This innovative adapter replaces your standard gas magazine, allowing you to power your VMP2 with HPA, fed by readily available CYMA airsoft shotgun shells.

Key Features

• Sites that do not usually allow HPA adapters in pistols should have no problem with these adapters, due to their low capacity, and covert profile.
• Compatible with most airsoft shotshells. Airtac recommends CYMA or Golden Eagle shells, as they have the strongest springs.
• 0 BBs are dropped when shell is empty (adapter will feed all 30 rounds of shell).
• An ambidextrous magazine catch is present at the rear of the adapter allowing easy shell drops.
• Three feed tubes of different lengths are included. Sometimes, due to manufacturing tolerances of the shells, you may need to swap out the feed tube already pre-fitted to give the best feeding results.

How to Fit:

Step One

Remove the paddle latch. This allows the adapter to sit correctly against the magwell.

Step Two

Pull the bolt back and hold. Always make sure you pull the bolt back before inserting the adapter. This avoids damaging the nozzle.

Step Three

Ensure the catch is seated. The adapter fits pretty snug so, make sure the catch is correctly seated. You might need to manually push the side release in to avoid damaging the adapter.

Additional Information

• If your Airsoft Rifle has an NPAS fitted, open it fully.
• Do not exceed 150 PSI. Most Airsoft Guns will not see an increase in FPS past this, as the hammer may struggle to depress the valve correctly.
• Insert the HPA adapter with your bolt/slide locked back to minimise pressure against the nozzle loading arm.

*DO NOT EXCEED 150PSI WITH ANY AIRSOFT HPA ADAPTER.

*ALWAYS USE AIR REGULATED BY A SECONDARY REGULATOR (EG AT200, WOLVERINE STORM, POLARSTAR MRS).

*CHECK YOUR PSI BEFORE CONNECTING AIR TO A HPA ADAPTER.

*NEVER CONNECT TO PAINTBALL AIR TANKS OR CO2 TANKS.

*NEVER CONNECT TO A TIPPMAN STYLE HPA LINE.