AirTac VFC PPSH to MP5 HPA Adapter

AirTac VFC PPSH to MP5 HPA Adapter

This adapter allows you to run HPA on your VFC PPSH with M4 AEG Magazines

Comes pre-fitted with valve, feed lips and gas router - you do not need to use any donor parts. No assembly is required.

AirTac utilise a very high flow valve. This has allowed them to build a far more reliable adapter that is capable of high FPS and sustained full auto.

Includes one set of spare feed lips.

US Style HPA Fitting as Standard (most common fitting across industry - compatible with all AIRTAC HPA equipment)

AIRTAC Adapters

Each of AirTac's adapters are designed to be low profile while reaching field limit FPS. They design and manufacture all of their products to the highest standard, and do not charge extra for ‘premium’ features. Where applicable this adapter features:

• Lifetime Warranty
• Injection moulded or CNC magwell that is impervious to BB strikes at point blank skirmish FPS.
• CNC or Injection moulded Feed Tubes and Magazine Catches for lifelong durability.
• Tuneability/compatability via integrated shim systems. AirTac's adapters are designed to cope with 'airsoft tolerances'
• Gas Routers injection moulded from NBR, 1:1 with the factory gas router.
• This adapter is ready to go out of the box. Valve, feed lips, and gas router are already fitted to the adapter. You do not need to use any donor parts.
• No assembly is required.
• MP5 HPA Adapter Info

AirTac test every HPA adapter they produce

• Seal Test
• Firing test, for feed and recoil
• Plug and Play

Features

• This magwell is made of CNC aluminium and cannot be damaged by BB strikes.
• Compatible with all CYMA MP5 Mid Caps (65 round metal, 120/130 round metal, Straight, Novritsch Straight, Bullet Window).
• BB Retention drops only 2 BBs when changing magazine

Fitment Instructions

• This magwell has a rear shim and a feed tube spacer.
• The feed tube shim fits under the feed tube. The rear shim is held in by two screws.
• Straight Magazines (Default Config) - Keep Shim In. Feed Tube spacer necessary on newer CYMA MP5 magazines
• Curved Long / Short Magazines - Remove rear shim. Keep Feed tube spacer in.
• If straight magazines will not feed with the rear shim and feed tube spacer installed, try removing the rear shim.
• In the very rare case short CYMA magazines do not fit your adapter, contact support@AIRTAC.me

Key Information

AirTac use a US Foster Fitting as standard. This is the most common airsoft HPA fitting.

Some of AirTac's HPA adapters have a smaller internal volume than gas magazines. Because of this, you will need to use a PSI of 90–150. If you need higher FPS, you can:

• Fit a tighter barrel
• Use a longer barrel
• Use heavier BBs
• Fit an improved hop bucking

If your replica has an NPAS fitted, AirTac advise opening it fully.

Do not exceed 150 PSI. Many airsoft guns will not see an increase in FPS past this, as the hammer may struggle to depress the valve correctly.

Insert the HPA adapter with your bolt / slide locked back to minimise pressure against the nozzle loading arm.